Commit Security Acl - 3Com WX4400 Command Reference Manual

commit security acl

To clear all physical ports, virtual ports, and VLANs on a WX switch of the
ACLs mapped for incoming and outgoing traffic, type the following
command:
WX4400# clear security acl map all
success: change accepted.
See Also
clear security acl on page 490
display security acl map on page 498
set security acl map on page 509
Saves a security ACL, or all security ACLs, in the edit buffer to the running
configuration and nonvolatile storage on the WX switch. Or, when used
with the clear security acl command, commit security acl deletes a
security ACL, or all security ACLs, from the running configuration and
nonvolatile storage.
Syntax — commit security acl {acl-name | all}
acl-name — Name of an existing security ACL to commit. ACL names
must start with a letter and are case-insensitive.
all — Commits all security ACLs in the edit buffer.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use the commit security acl command to save security ACLs
into, or delete them from, the permanent configuration. Until you
commit the creation or deletion of a security ACL, it is stored in an edit
buffer and is not enforced. After you commit a security ACL, it is removed
from the edit buffer.
A single commit security acl all command commits the creation and/or
deletion of whatever display security acl info all editbuffer shows to
be currently stored in the edit buffer.
commit security acl 493