Set Service-Profile Transmit-Rates - 3Com WX4400 Command Reference Manual

424 C 11: M
HAPTER
set service-profile
transmit-rates
A P C
ANAGED CCESS OINT OMMANDS
Defaults — Static CoS is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — The CoS level is specified by the set service-profile cos
command.
Examples — The following command enables static CoS on service
profile sp1:
WX4400# set service-profile sp1 static-cos enable
success: change accepted.
See Also
display service-profile on page 330
set service-profile cos on page 403
Changes the data rates supported by MAP radios for a service-profile's
SSID.
Syntax — set service-profile name transmit-rates {11a | 11b |
11g}
mandatory rate-list [disabled rate-list] [beacon-rate rate]
[multicast-rate {rate | auto}]
name — Service profile name.
11a | 11b | 11g — Radio type.
mandatory rate-list
are required to support in order to associate with an SSID on a MAP
radio. A client must support at least one of the mandatory rates.
These rates are advertised in the basic rate set of 802.11 beacons,
probe responses, and reassociation response frames sent by MAP
radios.
Data frames and management frames sent by MAP radios use one of
the specified mandatory rates.
— Set of data transmission rates that clients