Display Dap Global - 3Com WX4400 Command Reference Manual

324 C 11: M
HAPTER

display dap global

A P C
ANAGED CCESS OINT OMMANDS
Displays connection information for Distributed MAPs configured on a
WX switch.
Syntax —
display dap global [dap-num | serial-id serial-ID]
— Number of a Distributed MAP for which to display
dap-num
configuration settings.
serial-id serial-ID
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Connections are shown only for the Distributed MAPs that are
configured on the WX switch from which you enter the command, and
only for the Mobility Domain the switch is in.
To show information only for Distributed MAPs that have active
connections, use the display dap connection command.
Examples — The following command displays configuration information
for all the Distributed MAPs configured on a WX switch:
WX4400# display dap global
Total number of entries: 8
DAP Serial Id
--- -----------
1 M9DE48B012F00 10.3.8.111
- M9DE48B012F00 10.4.3.2
2 M9DE48B123400 10.3.8.111
- M9DE48B123400 10.4.3.2
17 M9DE48B123600 10.3.8.111
- M9DE48B123600 10.4.3.2
18 M9DE48B123700 10.3.8.111
- M9DE48B123700 10.4.3.2
Table 61 describes the fields in this display.
— MAP access point serial ID.
WX IP Address Bias
--------------- ----
HIGH
LOW
LOW
HIGH
HIGH
LOW
LOW
HIGH