Set Boot Backup-Configuration - 3Com WX4400 Command Reference Manual

634 C 20: F
HAPTER ILE
set boot
backup-configuration
M C
ANAGEMENT OMMANDS
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you do not specify a filename, MSS replaces the
configuration file loaded during the most recent reboot. To display the
filename of the configuration file MSS loaded during the most recent
reboot, use the display boot command.
The command completely replaces the specified configuration file with
the running configuration.
Examples — The following command saves the running configuration to
the configuration file loaded during the most recent reboot. In this
example, the filename used during the most recent reboot is
configuration.
WX4400# save config
Configuration saved to configuration.
The following command saves the running configuration to a file named
testconfig1:
WX4400# save config testconfig1
Configuration saved to testconfig1.
See Also
display boot on page 622
display config on page 623
load config on page 627
Specifies the name of a backup configuration file to be used in the event
that MSS cannot read the WX switch's configuration file at boot time.
Syntax — set boot backup-configuration filename
filename —Name of the file to use as a backup configuration file if
MSS cannot read the WX switch's configuration file.
Defaults — By default, there is no backup configuration file.
Access — Enabled.