System; Commands By Usage - 3Com WX4400 Command Reference Manual

3
Commands by
Usage
S S
YSTEM
Use system services commands to configure and monitor system
information for a WX switch.
This chapter presents system service commands alphabetically. Use
Table 6 to locate commands in this chapter based on their use.
Table 6 System Services Commands by Usage
Type
Configuration
Auto-Config
Display
System Identification
C
ERVICE OMMANDS
Command
quickstart on page 50
set auto-config on page 50
clear banner motd on page 40
quickstart on page 50
display banner motd on page 43
set confirm on page 53
set length on page 54
set prompt on page 56
set system name on page 65
set system location on page 64
set system contact on page 57
set system countrycode on page 58
set system idle-timeout on page 62
set system idle-timeout on page 62
display load on page 45
display system on page 45
clear system on page 42