Set Service-Profile Cac-Mode - 3Com WX4400 Command Reference Manual

set service-profile
cac-mode
enable — Enables beaconing of the SSID managed by the service
profile.
disable — Disables beaconing of the SSID managed by the service profile.
Defaults — Beaconing is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command disables beaconing of the SSID
managed by service profile sp2:
WX4400# set service-profile sp2 beacon disable
success: change accepted.
See Also
display service-profile on page 330
set radio-profile beacon-interval on page 373
set service-profile ssid-name on page 421
set service-profile ssid-type on page 422
Configures the Call Admission Control (CAC) mode.
Syntax — set service-profile name cac-mode {none | session}
name — Service profile name.
none — CAC is not used.
session — CAC is based on the number of active sessions.
Defaults — The default CAC mode is none.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Examples — The following command enables session-based CAC on
service profile sp1:
WX4400# set service-profile sp1 cac-mode session
success: change accepted.

set service-profile cac-mode

397