Snmpv3 With Traps; Snmpv2C With Informs - 3Com WX4400 Command Reference Manual

SNMPv3 with Traps

SNMPv2c with
Informs
To configure a notification target for traps from SNMPv3, use the
following command:
Syntax —
set snmp notify target target-num ip-addr[:udp-port-number]
usm trap user username
[profile profile-name]
[security {unsecured | authenticated | encrypted}]
— ID for the target. This ID is local to the WX switch and
target-num
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
ip-addr [ :udp-port-number
specify the UDP port number to send notifications to.
— USM username. This option is applicable only when the
username
SNMP version is usm.
profile profile-name
to specify the notification types to send or drop.
—
security
{unsecured |
authenticated |
encrypted}
To configure a notification target for informs from SNMPv2c, use the
following command:
Syntax —
set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string inform
[profile profile-name]
[retries num]
[timeout num]
target-num — ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
] — IP address of the server. You also can
— Notification profile this SNMP user will use
Specifies the security level, and is applicable only
when the SNMP version is usm:
- — Message exchanges are not
unsecured
authenticated, nor are they encrypted. This is
the default.
- authenticated — Message exchanges are
authenticated, but are not encrypted.
- — Message exchanges are
encrypted
authenticated and encrypted.
set snmp notify target 187