Clear Network-Domain Seed-Ip - 3Com WX4400 Command Reference Manual

clear
network-domain
seed-ip
Removes the specified Network Domain seed from the WX switch's
configuration. When you enter this command, the Network Domain TCP
connections between the WX switch and the specified Network Domain
seed are closed.
Syntax —
clear network-domain seed-ip ip-addr
— IP address of the Network Domain seed in dotted decimal notation.
ip-addr
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX switch is not configured as
part of a Network Domain, or if the WX switch is not configured as a
member of a Network Domain that uses the specified Network Domain seed.
The following command removes the Network Domain seed with IP
address 192.168.9.254 from the WX switch's configuration:
WX1200# clear network-domain seed-ip 192.168.9.254
success: change accepted.
See Also
set network-domain mode member seed-ip on page 284

clear network-domain seed-ip

281