Set Snmp Notify Target; Snmpv3 With Informs - 3Com WX4400 Command Reference Manual

set snmp notify
target

SNMPv3 with Informs

WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedSsidAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedOuiTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedSsidTraps
success: change accepted.
See Also
clear snmp notify profile on page 137
set ip snmp server on page 173
set snmp community on page 179
set snmp notify target on page 185
set snmp protocol on page 190
set snmp security on page 191
set snmp usm on page 192
set snmp notify profile on page 181
Configures a notification target for notifications from SNMP.
A notification target is a remote device to which MSS sends SNMP
notifications. You can configure the MSS SNMP engine to send confirmed
notifications (informs) or unconfirmed notifications (traps). Some of the
command options differ depending on the SNMP version and the type of
notification you specify. You can configure up to 10 notification targets.
To configure a notification target for informs from SNMPv3, use the
following command:
Syntax —
set snmp notify target target-num
ip-addr[:udp-port-number]
usm inform user username
snmp-engine-id {ip | hex hex-string}

set snmp notify target

185