Display Dap Unconfigured - 3Com WX4400 Command Reference Manual

display dap
unconfigured
Table 61 Output for display dap global
Field
DAP
Serial Id
WX IP Address
Bias
See Also
display {ap | dap} config on page 296
display dap connection on page 322
display dap unconfigured on page 325
set dap on page 85
set {ap | dap} bias on page 343
Displays Distributed MAPs that are physically connected to the network
but that are not configured on any WX switches.
Syntax —

display dap unconfigured

Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command also displays a MAP that is directly connected to
a WX switch, if the WX port to which the MAP is connected is configured
as a network port instead of a MAP access port, and if the network port is
a member of a VLAN.
Description
Connection ID you assigned to the Distributed MAP.
Note: DAP numbers are listed only for Distributed MAPs
configured on this WX switch. If the field contains a
hyphen ( - ), the Distributed MAP configuration displayed in
the row of output is on another WX switch.
Serial ID of the Distributed MAP.
System IP address of the WX switch on which the Distributed
MAP is configured. A separate row of output is displayed for
each WX switch on which the Distributed MAP is configured.
Bias of the WX switch for the Distributed MAP:
High
Low
display dap unconfigured 325