Display Port Counters - 3Com WX4400 Command Reference Manual

display port
counters
Table 10 Network port defaults
Port Parameter
VLAN membership
Spanning Tree Protocol (STP) Based on the VLAN(s) you add the port to.
802.1X
Port groups
Internet Group Management
Protocol (IGMP) snooping
Access point and radio
parameters
Maximum user sessions
Examples — The following command clears port 5:
WX1200# clear port type 5
This may disrupt currently authenticated users.
Are you sure? (y/n) [n]y
success: change accepted.
See Also
set port type ap on page 95
set port type wired-auth on page 98
Displays port statistics.
Syntax —

display port counters

[octets | packets | receive-errors | transmit-errors |
collisions | receive-etherstats
transmit-etherstats] [port port-list]
octets — Shows octet statistics.
— Shows packet statistics.
packets
receive-errors
transmit-errors
— Shows collision statistics.
collisions
Setting
None.
Note: Although the command changes a port to a
network port, the command does not place the port
in any VLAN. To use the port in a VLAN, you must
add the port to the VLAN.
No authorization.
None.
Enabled as port is added to VLANs.
Not applicable
Not applicable
|
— Shows errors in received packets.
— Shows errors in transmitted packets.
display port counters 73