Set Dap Auto - 3Com WX4400 Command Reference Manual

set dap auto

Creates a profile for automatic configuration of Distributed MAPs.
Syntax —
set dap auto
Defaults — None.
Access — Enabled.
History — Introduced in MSS 4.0.
Usage — Table 65 lists the configurable profile parameters and their
defaults. The only parameter that requires configuration is the profile
mode. The profile is disabled by default. To use the profile to configure
Distributed MAPs, you must enable the profile using the set dap auto
mode enable command.
The profile uses the default radio profile by default. You can change the
profile using the set dap auto radio radio-profile command. You can
use set dap auto commands to change settings for the parameters listed
in Table 65. (The commands are listed in the "See Also" section.)
Table 65 Configurable Profile Parameters for Distributed MAPs
Parameter
MAP Parameters
mode
bias
upgrade-firmware
(boot-download-enable)
group (load balancing group)
blink
(Not shown in display dap config
output)
Radio Parameters
radiotype
mode
Default Value
disabled
high
enable (YES)
none
disable
11g
(or 11b for country codes where
802.11g is not allowed)
enabled
set dap auto 339