Set Dap Boot-Switch - 3Com WX4400 Command Reference Manual

set dap boot-switch

Examples — The following command configures Distributed MAP 1 to
use IP address 172.16.0.42 with a 24-bit netmask, and use 172.16.0.20
as its default gateway:
WX4400# set dap 1 boot-ip ip 172.16.0.42 netmask
255.255.255.0 gateway 172.16.0.20 mode en
success: change accepted.
See Also
clear dap boot-configuration on page 293
set dap boot-switch on page 347
set dap boot-vlan on page 349
display dap boot-configuration on page 321
Specifies the WX switch a Distributed MAP contacts and attempts to use
as its boot device.
Syntax — set dap dap-num boot-switch [switch-ip ip-addr]
[name name dns ip-addr] [mode {enable | disable}]
dap dap-num — Number of the Distributed MAP for which you are
specifying static IP information.
switch-ip ip-addr — The IP address of the WX switch the Distributed
MAP should boot from.
name name — The fully qualified domain name of the WX switch the
Distributed MAP should boot from. When both a name and a
switch-ip are specified, the MAP uses the name.
dns ip-addr — The IP address of the DNS server used to resolve the
specified name of the WX switch.
{ |
mode enable disable
specified boot device.
Defaults — By default MAPs use the process described in "Default MAP
Boot Process", in the
Guide to boot from a WX switch, instead of using a manually specified
WX switch.
Examples — Enabled.
} — Enables or disables the MAP using the
Wireless LAN Switch and Controller Configuration
set dap boot-switch 347