Boot Prompt Commands By Usage - 3Com WX4400 Command Reference Manual

24
Boot Prompt
Commands by
Usage
B P
OOT ROMPT
Boot prompt commands enable you to perform basic tasks, including
booting a system image file, from the boot prompt (boot>). A CLI session
enters the boot prompt if MSS does not boot successfully or you
intentionally interrupt the boot process. To interrupt the boot process,
press q followed by Enter (return).
CAUTION: Generally, boot prompt commands are used only for
troubleshooting. 3Com recommends that you use these commands only
when working with 3Com Technical Support to diagnose a system issue.
In particular, commands that change boot parameters can interfere with
a WX switch's ability to boot successfully.
This chapter presents boot prompt commands alphabetically. Use
Table 112 to locate commands in this chapter based on their use.
Table 112 Boot Prompt Commands by Usage
Type
Command Information
Booting
File Management
C
OMMANDS
Command
ls on page 682
help on page 681
boot on page 671
reset on page 684
autoboot on page 670
dhcp on page 676
dir on page 677
fver on page 680
version on page 686