Set Igmp - 3Com WX4400 Command Reference Manual

set igmp

Table 79 Output of display igmp statistics (continued)
Field Description
Topology Number of Layer 2 topology change notifications received by the
notifications WX.
In the current software version, the value in this field is always 0.
Packets with Number of multicast packets received with an unrecognized
unknown multicast type.
IGMP type
Packets with Number of packets with an invalid length.
bad length
Packets with Number of packets with an invalid IGMP checksum value.
bad IGMP
checksum
Packets Number of multicast packets dropped by the WX.
dropped
See Also
clear igmp statistics on page 466
Disables or reenables IGMP snooping on one VLAN or all VLANs on a
wireless LAN switch.
Syntax — set igmp {enable | disable} [vlan vlan-id]
enable — Enables IGMP snooping.
disable — Disables IGMP snooping.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, IGMP snooping is disabled or reenabled on all VLANs.
History — Introduced in MSS Version 3.0.
Examples — The following command disables IGMP snooping on VLAN
orange:
WX1200# set igmp disable vlan orange
success: change accepted
See Also
set igmp rv on page 486
set igmp 477