System; Commands By Usage; Clear Log - 3Com WX4400 Command Reference Manual

23
Commands by
Usage

clear log

S L
YSTEM
Use the system log commands to record information for monitoring and
troubleshooting. MSS system logs are based on RFC 3164, which defines
the log protocol.
This chapter present system log commands alphabetically. Use Table 111
to locate commands in this chapter based on their use.
Table 111 System Log Commands by Usage
Type Command
System Logs set log on page 664
set log mark on page 667
display log buffer on page 660
display log config on page 662
display log trace on page 663
clear log on page 659
Clears the log messages stored in the log buffer, or removes the
configuration for a syslog server and stops sending log messages to that
server.
Syntax —
clear log [buffer | server ip-addr]
— Deletes the log messages stored in nonvolatile storage.
buffer
server ip-addr
log messages to the syslog server at this IP address. Specify an address
in dotted decimal notation.
Defaults — None.
C
OG OMMANDS
— Deletes the configuration for and stops sending