Set Rfdetect Vendor-List - 3Com WX4400 Command Reference Manual

608 C 19: RF D
HAPTER
set rfdetect
vendor-list
C
ETECTION OMMANDS
Adds an entry to the permitted vendor list. The permitted vendor list
specifies the third-party AP or client vendors that are allowed on the
network. MSS does not list a device as a rogue or interfering device if the
device's OUI is in the permitted vendor list.
Syntax —
set rfdetect vendor-list {client | ap} mac-addr
client | ap
client brand.
— Organizationally Unique Identifier (OUI) to remove.
mac-addr
Defaults — The permitted vendor list is empty by default and all vendors
are allowed. However, after you add an entry to the list, MSS allows only
the devices whose OUIs are on the list.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The permitted vendor list applies only to the WX switch on
which the list is configured. WX switches do not share permitted vendor
lists.
If you add a device that MSS has classified as a rogue to the permitted
vendor list, but not to the ignore list, MSS can still classify the device as a
rogue. Adding an entry to the permitted vendor list merely indicates that
the device is from an allowed vendor. However, to cause MSS to stop
classifying the device as a rogue, you must add the device's MAC address
to the ignore list.
Examples — The following command adds an entry for clients whose
MAC addresses start with aa:bb:cc:
WX1200# set rfdetect vendor-list client aa:bb:cc:00:00:00
success: MAC aa:bb:cc:00:00:00 is now in client vendor-list.
The trailing 00:00:00 value is required.
See Also
clear rfdetect vendor-list on page 583
display rfdetect vendor-list on page 597
— Specifies whether the entry is for an AP brand or a