Display Spantree Blockedports - 3Com WX4400 Command Reference Manual

444 C 12: STP C
HAPTER
display spantree
blockedports
WX4400# display spantree blockedports vlan default
Port
------------------------------------------------------------------------
2
Number of blocked ports (segments) in VLAN 1 : 1
OMMANDS
Examples — The following example shows the command output on a
WX switch with backbone fast convergence enabled:
WX4400# display spantree backbonefast
Backbonefast is enabled
See Also
set spantree backbonefast on page 454
Lists information about wireless LAN switch ports that STP has blocked on
one or all of its VLANs.
Syntax — display spantree blockedports [vlan vlan-id]
vlan vlan-id
MSS displays information for blocked ports on all VLANs.
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Usage — The command lists information separately for each VLAN.
Examples — The following command shows information about blocked
ports on a WX switch for the default VLAN (VLAN 1):
Vlan Port-State
190 Blocking
The port information is the same as the information displayed by the
display spantree command. See Table 69 on page 441.
See Also
display spantree on page 440
— VLAN name or number. If you do not specify a VLAN,
Cost
4
Prio Portfast
128 Disabled