3Com WX4400 Command Reference Manual page 311

WX4400# display dap status 1
Dap: 1, IP-addr: 10.2.34.56 (vlan 'vlan-corp'), MAP model: AP2750,
manufacturer: 3Com, name: DAP01
fingerprint: b4
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
Uptime: 21 hours, 27 minutes, 51 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:94, ssid: private
Access — Enabled.
History —Introduced in MSS Version 3.0. True base MAC addresses of
radios are displayed in MSS Version 3.2. Previously, the base MAC
address displayed for a radio was the true base MAC address plus 2. Note
that a radio's base MAC address is also used as the BSSID of the first SSID
configured on the radio. New option added: terse; new option added for
display dap status: all; new field added: fingerprint; MAP-WX security
status added to State field in MSS Version 4.0. External antenna
information added after the radio state information, to indicate when an
antenna has been detected and to indicate the configured antenna
model number; auto flag added to indicate operational channel or power
settings that are configured by RF Auto-Tuning in MSS Version 4.1.
Version 4.2 added Radar Scan and Radar Detected flags to indicate when
the Dynamic Frequency Selection (DFS) feature is scanning for radar or
has stopped transmitting due to detected radar. The flags apply to
802.11a radios only, and only for country codes where DFS is used
Examples — The following command displays the status of a Distributed
MAP:
:
f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
id=0x28f10158a47f0408 ram=33554432
s/n=0332600444 hw_rev=A3
display {ap | dap} status 311