Set Snmp Security - 3Com WX4400 Command Reference Manual

set snmp security

set snmp security on page 191
set snmp usm on page 192
display snmp status on page 157
Sets the minimum level of security MSS requires for SNMP message
exchanges.
Syntax —
set snmp security
{unsecured | authenticated | encrypted | auth-req-unsec-notify}
— SNMP message exchanges are not secure. This is the
unsecured
only value supported for SNMPv1 and SNMPv2c.
— SNMP message exchanges are authenticated but
authenticated
are not encrypted.
encrypted — SNMP message exchanges are authenticated and
encrypted.
auth-req-unsec-notify
authenticated but are not encrypted, and notifications are neither
authenticated nor encrypted.
Defaults — By default, MSS allows nonsecure (unsecured) SNMP
message exchanges.
Access — Enabled.
History — Introduced in MSS Version 4.0.
Usage — SNMPv1 and SNMPv2c do not support authentication or
encryption. If you plan to use SNMPv1 or SNMPv2c, leave the minimum
level of SNMP security set to unsecured.
Examples — The following command sets the minimum level of SNMP
security allowed to authentication and encryption:
WX1200# set snmp security encrypted
success: change accepted.
— SNMP message exchanges are
set snmp security 191