Set {Ap | Dap} Radio Auto-Tune Min-Client-Rate - 3Com WX4400 Command Reference Manual

set {ap | dap} radio
auto-tune
min-client-rate
See Also
display {ap | dap} config on page 296
set {ap | dap} radio tx-power on page 363
Sets the minimum rate at which a radio is allowed to transmit traffic to
clients. The radio automatically increases its transmit power when
necessary to maintain at least the minimum rate with an associated client.
Syntax —
set {ap port-list | dap dap-num
auto-tune min-client-rate rate
ap port-list — List of ports connected to the MAP access points on
which to set the channel.
dap dap-num — Number of a Distributed MAP on which to set the
channel.
dap auto — Sets the radio mode for MAPs managed by the MAP
configuration profile. (See set dap auto on page 339.)
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
rate — Minimum data rate, in megabits per second (Mbps). The valid
values depend on the radio type:
For 802.11g radios—54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1
For 802.11b radios—11, 5.5, 2, or 1
For 802.11a radios—54, 48, 36, 24, 18, 12, 9, or 6
Defaults — The default minimum data transmit rate depends on the
radio type:
The default minimum data rate for 802.11b/g and 802.11b radios is
5.5 Mbps.
The default minimum data rate for 802.11a radios is 24 Mbps.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.

set {ap | dap} radio auto-tune min-client-rate

359
| auto} radio {1 | 2}