Display Config - 3Com WX4400 Command Reference Manual

display config

Table 106 describes the fields in the display boot output.
Table 106 Output for display boot
Field
Configured boot
version
Configured boot
image
Configured boot
configuration
Backup boot
configuration
Booted version
Booted image
Booted configuration Configuration filename MSS used to load the configuration
See Also
display version on page 625
reset system on page 631
set boot configuration-file on page 635
Displays the configuration running on the WX switch.
Syntax — display config [area area] [all]
area area — Configuration area. You can specify one of the
following:
aaa
acls
ap
arp
eapol
httpd
ip
Description
Software version the switch will run next time the software is
rebooted.
Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configuration filename MSS will use to boot next time the
software is rebooted.
The name of the configuration file to be used in the event
that MSS cannot read the configured boot configuration file
next time the software is rebooted.
Software version the switch is running.
Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
the last time the software was rebooted.
display config 623