3Com WX4400 Command Reference Manual page 389

Table 67 Defaults for Service Profile Parameters (continued)
Parameter
wep key-index
wep active-
multicast-index
wep active-unicast-
index
wpa-ie
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must configure the service profile before you can map it to
a radio profile. You can map the same service profile to more than one
radio profile.
You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.
Examples — The following command maps service-profile wpa_clients
to radio profile rp2:
WX4400# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
display radio-profile on page 327
display service-profile on page 330
set service-profile attr on page 391
set service-profile auth-dot1x on page 393
set service-profile auth-fallthru on page 394
set service-profile auth-psk on page 395
set service-profile beacon on page 396
set radio-profile service-profile
Radio Behavior When Parameter Set
Default Value to Default Value
No keys Uses dynamic WEP rather than static WEP.
defined
If you configure a WEP key for static WEP,
MSS continues to also support dynamic
WEP.
1 Uses WEP key 1 for static WEP encryption
of multicast traffic if WEP encryption is
enabled and keys are defined.
1 Uses WEP key 1 for static WEP encryption
of unicast traffic if WEP encryption is
enabled and keys are defined.
disable Does not use the WPA IE in transmitted
frames.
389