Set Radio-Profile Frag-Threshold - 3Com WX4400 Command Reference Manual

376 C 11: M
HAPTER
set radio-profile
frag-threshold
A P C
ANAGED CCESS OINT OMMANDS
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
The DTIM interval does not apply to unicast frames.
Examples — The following command changes the DTIM interval for
radio profile rp1 to 2:
WX4400# set radio-profile rp1 dtim-interval 2
success: change accepted.
See Also
display radio-profile on page 327
set radio-profile mode on page 380
Changes the fragmentation threshold for the MAP radios in a radio
profile. The fragmentation threshold is the threshold at which the
long-retry-count is applicable insted of the short-retry-count.
The long-retry-count specifies the number of times a radio can send a
unicast frame that is equal to or longer than the frag-threshold without
receiving an acknowledgment.
The short-retry-count specifies the number of times a radio can send a
unicast frame that is shorter than the frag-threshold without receiving an
acknowledgment.
Syntax — set radio-profile name frag-threshold threshold
name — Radio profile name.
threshold
from 256 through 2346.
Defaults — The default fragmentation threshold for MAP radios is 2346
bytes.
Access — Enabled.
History —Introduced in MSS Version 3.0.
— Maximum frame length, in bytes. You can enter a value