Table of Contents
Advertisement
5. QUICK START GUIDE
5.1
Communication Port Selection
Figure 3. USB to RS232 converter and new COM port assigned from Windows OS
A USB-to-RS232 or USB-to-RS422 converter can be used to implement serial communication.
Most computers have USB ports as configurable serial communication ports. After the converter
driver is installed and recognized by the Windows OS, the specific communication port can be
found in the "Device Manager" of the Windows OS. Figure 3 includes a representative USB-to-
RS232 converter and a screenshot of the designated communication port assigned by Windows
OS, the "COM9." The designated COM port number can then be entered in the settings window
for Terminal emulators.
5.2
Cable Connections
Figure 4 includes the Boson+ CZ 14-75 with the Camera Link® accessory board installed. The
power/comm cable for the lens controller should be connected to the 6-pin Molex PicoBlade
connector (Molex 53261-0671). The micro-USB 3.0 cable should be connected to the Camera
Link accessory board to provide power to the camera and stream the video signal.
Document M-008 Revision A. Approved for public release: Teledyne FLIR approved [FLIRGTC-SBA-018].
© 2023 Teledyne FLIR
BOSON+ CZ 14-75 USER MANUAL
Page 6
Advertisement
Table of Contents
