Table of Contents
Advertisement
5.3.3.3 External Output
DeepView for Windows allows you to record the survey data acquired by the 440 System.
To edit these settings, select Configuration
Figure 5-11: External Output Configuration and Serial Port menu
Table 5-5: External Output Configuration
External Output Configuration
External Data
In 440 mode, the system always outputs a sentence which combines the signal and coordi-
Output Type:
nate information.
See
mats.
External Data
The SDC can transmit data to the data logger at either four records or one record per sec-
Output Rate:
ond. The default setting is four records per second.
You should consider the available storage space and the desired linear track resolution for
the survey before you decide between these alternatives.
External Output
This box must be checked to enable the external output. If it is enabled, then a tick will
Enabled
appear against the "external output" item in the "configuration" menu.
Configure EXT
Options to configure, COM Port, Baud Rate, Data Bits, Parity and Stop Bits. See Figure 5-11.
Serial Port
DPN 402196 Issue 4.1
➥
External Output. Note external logging is defaulted to on.
section 6.3.7 "Data Logging" on page 6-19
© Teledyne TSS
5 – Operating Software
for a description of these data for-
5- 23
Advertisement
Table of Contents
