Table of Contents
Advertisement
9.3
Resetting the program
To restart a program stopped with
n
NOTE
The output is also reset when the program is reset. However, the output will
not be reset in the following cases:
1. "DO cond. on PGM reset / RESCDO" in Other parameters is set to "HOLD".
(For details, see "13. DO cond. on PGM reset / RESCDO" in "12.1.4 Other
parameters".)
2. A sequence program is being executed without enabling the DO reset in
the sequence execution flag setting.
[Procedure]
■ Program reset (1)
AUTO
1
'***** TEST1 PROGRAM *****
2 START *SUBTASK,T2
3 DO2(0)=0
4 WAIT DI3(4,3,2)=3
5 MOVE P,P0
RESET
TASK
• When the program "_SELECT" does not exist:
1) Press
(RESET) in "AUTO" mode.
2) Press
(YES).
The program listing appears from the first line. (A pointer also appears on the first line
number of the program.)
■ Program reset (2)
AUTO
1
*ST:
2
MOVE P, P0
3
MOVE P, P1
4
MOVE P, P2
5
GOTO *ST
Reset program OK?
from the beginning, reset the program.
[T1] 100% <TEST1
DIR
VEL+
VEL-
[T1] 50% <TEST1
YES
NO
9. "AUTO" mode
>
>
Chapter
4
4-35
Advertisement
Table of Contents
