Table of Contents
Advertisement
12. "SYSTEM" mode
11. Ser vo on when power on / SRVOON
Use this parameter to select whether to start the controller with servo-on or servo-off
when the controller power is turned on.
When robot numbers are set by generation, this parameter is reset to "YES".
YES
Chapter
4
NO
[Procedure]
1) Select "11. Servo on when power on" in "SYSTEM>PARAM>OTHERS" mode.
2) Press
■ Setting "Ser vo on when power on"
ＳＹＳＴＥＭ＞ＰＡＲＡＭ＞ＯＴＨＥＲＳ
１０．ＭＯＶＥＩ／ＤＲＩＶＥＩ ｓｔａｒｔ ｐｏｓ． Ｋｅｅｐ
１１．Ｓｅｒｖｏ ｏｎ ｗｈｅｎ ｐｏｗｅｒ ｏｎ ＹＥＳ
ＹＥＳ ＮＯ
3) Press
4) Press
n
NOTE
• This parameter is supported by controllers of Ver. 9.17 onwards. On earlier
• This parameter is set to "YES" at the time of shipment.
4-196
Setting
When SAFE mode setting or serial I/O setting is enabled, the
controller starts with servo-off when the controller power is
turned on.
In other cases, the controller starts with servo-on when the
controller power is turned on.
(Compatibility mode for the RCX141/142 controllers)
The controller always starts with servo-off when the power is
turned on.
(Compatibility mode for the RCX143/144 controllers)
(EDIT).
７．ＴＲＵＥ ｃｏｎｄｉｔｉｏｎ −１
８．Ｕｎｉｔ ｓｅｌｅｃｔ Ｎｏｒｍａｌ
９．Ｅｒｒｏｒ ｏｕｔｐｕｔ（ＤＯ ＆ ＳＯ） Ｏｆｆ
(YES) or
(NO) to enter the setting.
to quit the edit mode.
version controllers, the operation starts in the same way as in the case
where this parameter is set to "YES".
Meaning
Ｖ９．2 ３
Advertisement
Table of Contents
