Yamaha RCX222 User Manual page 20

Warming label 8 (controllers RCX240, controllers RCX340)
■
w
WARNING
These are precautions for YAMAHA and distributors' service personnel.
Customers must not attempt to open the covers.
w
WARNING
Wait at least 100 seconds after power-off before opening the covers.
Potential hazard to human body
To avoid hazard
* These are precautions for YAMAHA and distributors' service personnel. Customers must not attempt to open the covers.
Warning label 9 (single-axis linear motor robots)
■
c
CAUTION
A magnetic scale is located inside this cover. Bringing a magnet close to it may cause malfunction.
Warning label 10 (single-axis linear motor robots)
■
c
CAUTION
Powerful magnets are installed in the robot.
Do not attempt to disassemble the robot to avoid possible injury.
Do not bring any device that may malfunction due to magnetic fields close to the robot.
Potential hazard to human body
To avoid hazard
S-6
• Wait at least 100 seconds after power-off
before opening the covers (*).
• Some parts in the controller still retain a high
voltage even after power-off, so electrical
shock may occur if those parts are touched.
Electrical shock
Wait at least 100 seconds after power-off before opening the covers (*).
• To prevent the robot from operating improperly due
to magnetic scale malfunction, do not bring a strong
magnet to the cover.
• Do not bring tools close to the magnetic scale.
Be sure to read "6. Cautions regarding strong magnetic
fields" in "Safety instructions" and make sure you fully
understand its contents before handling or operating
the robot.
Injury or death may result in some cases.
Make you understand the precautions regarding strong magnetic fields.
Instructions on this label
Instructions on this label
Instructions on this label
90K41-001390
90K41-001510
90K41-001500