Brake Fluid Replacement/Air Bleeding; Brake Fluid Draining - Honda CRF1000 Shop Manual

dummyhead dummyhead
HYDRAULIC BRAKE
BRAKE FLUID REPLACEMENT/AIR
BLEEDING

BRAKE FLUID DRAINING

Turn the handlebar until the reservoir is parallel to the
Front brake:
ground.
Remove the following:
– Screws [1]
– Reservoir cap [2]
– Set plate [3]
– Diaphragm [4]
Support the motorcycle in an upright position.
Rear brake:
Remove the mounting bolt [1] and release the rear
brake reserve tank [2] from the rear frame.
Remove the screws [3], reservoir cap [4], set plate [5],
and diaphragm [6].
Temporarily install the reserve tank and bolt, and
tighten the bolt.
Connect a bleed hose to the caliper bleed valve [1].
Loosen the bleed valve and pump the brake lever/pedal
until no more fluid flows out of the bleed valve.
Tighten the bleed valve.
19-6
[1]
[2]
[3]
[4]
[3]
[4]
[5]
[6]
[2]
[1]
Front: Rear:
[1]
[1]