Primary Drive Gear Removal - Honda CRF1000 Shop Manual

dummyhead dummyhead
Install the clutch springs [1], set plate [2] and set plate
bolts [3].
Tighten the set plate bolts in a crisscross pattern in 2 or
3 steps to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 0.9 lbf·ft)
PRIMARY DRIVE GEAR
REMOVAL
Remove the following:
– Cylinder head (page 10-13)
– Rear balancer (page 14-9)
– Clutch (page 12-8)
Remove the cam chain tensioner pivot bolt [1], cam
chain tensioner [2], and washer [3].
Remove the bolts [4], cam chain guide plate [5], and
cam chain [6].
Line up the primary drive gear and sub gear teeth by
inserting a suitable pin [1] into the holes of gears.
Hold the primary drive gear and sub-gear with a 6 mm
bolt [2].
Temporarily install the clutch outer [1].
Install the special tool between the primary drive and
driven gears, and remove the primary drive gear bolt [2]
and washer [3].
TOOL:
Gear holder, 2.5 [4]
Remove the gear holder and clutch outer.
CLUTCH/GEARSHIFT LINKAGE (CRF1000/A)
[1]/[3]
[1]/[3]
[2]
07724-0010100
[2]
[1] [4]
12-15
[2]
[6]
[5]
[4]
[1]
[3]
[2]