Primary Drive Gear Removal - Honda VTR1000F Service Manual

CLUTCH/GEARSHIFT LINKAGE
Install the thrust washer onto the gearshift spindle,
and insert the spindle into the crankcase, aligning
the return spring ends with the spring pin.
Install the gearshift arm onto the spindle, aligning
the slit of the arm with the punch mark on the
spindle.
Tighten the gearshift arm bolt securely.
Assemble the clutch (page 9-17).
PRIMARY DRIVE GEAR
REMOVAL
9-22
Disassemble the clutch to the clutch center thrust
washer (page 9-12),
Install the special tool between the primary drive
and driven gears as shown, loosen the primary
drive gear bolt, and remove the bolt and special
washer.
TOOL:
Gear holder
07724-0010100
Remove the clutch outer (page 9-13).
Remove the ignition pulse generator rotor and pri-
mary drive gear assembly.