Lldp (802.1Ab) Commands; Show Port-Security Static; Show Port-Security Violation - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Term Definition
MAC Address MAC Address of dynamically locked MAC.

show port-security static

This command displays the statically locked MAC addresses for port.
Format
show port-security static <unit/slot/port>
Mode Privileged EXEC
Term Definition
MAC Address MAC Address of statically locked MAC.

show port-security violation

This command displays the source MAC address of the last packet discarded on a locked port.
Format
show port-security violation <unit/slot/port>
Mode Privileged EXEC
Term Definition
MAC Address MAC Address of discarded packet on locked port.

LLDP (802.1AB) Commands

This section describes the command you use to configure Link Layer Discovery Protocol (LLDP),
which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802 LAN to
advertise major capabilities and physical descriptions. The advertisements allow a network
management system (NMS) to access and display this information.
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-170