Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
6.3 Provisioning (IEEE 802.1p) Commands
This section describes the commands you use to configure provisioning, which allows you
to prioritize ports.
6.3.1 vlan port priority all
This command configures the port priority assigned for untagged packets for all ports
presently plugged into the device. The range for the priority is 0-7. Any subsequent per
port configuration will override this configuration setting.
Format
Mode
6.3.2 vlan priority
This command configures the default 802.1p port priority assigned for untagged packets
for a specific interface. The range for the priority is 0-7
Default
Format
Mode
6-14
vlan port priority all <priority>
Global Config
0
vlan priority <priority>
Interface Config
v1.0, December 2005
VLAN Commands