Port Lacptimeout (Global Config); Port-Channel Adminmode; Port-Channel Linktrap - NETGEAR M6100 Series Reference Manual

port lacptimeout (Global Config)

This command sets the timeout for all interfaces of a particular device type (actor or partner)
to either long or short timeout.
Default long
Format
port lacptimeout {actor | partner} {long | short}
Mode Global Config
no port lacptimeout
This command sets the timeout for all physical interfaces of a particular device type (actor or
partner) back to their default values.
Format
no port lacptimeout {actor | partner}
Mode Global Config
Note: Both the no portlacptimeout and the no lacp actor admin
state commands set the values back to default, regardless of the
command used to configure the ports. Consequently, both commands
display in the output of the show running-config command.

port-channel adminmode

This command enables all configured port-channels with the same administrative mode
setting.
Format
port-channel adminmode all
Mode Global Config
no port-channel adminmode
This command disables all configured port-channels with the same administrative mode
setting.
Format
no port-channel adminmode all
Mode Global Config

port-channel linktrap

This command enables link trap notifications for the port-channel (LAG). The interface is a
logical unit/slot/port for a configured port-channel. The option all sets every
configured port-channel with the same administrative mode setting. Instead of
unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the
LAG interface, in which lag-intf-num is the LAG port number.
M6100 Series Switches
Switching Commands
455