Qos Port Defaults; Policy Rule Defaults - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring QoS

QoS Port Defaults

Use the qos port reset
Description
The default 802.1p value inserted
into packets received on
untrusted ports.
The default DSCP value inserted
into packets received on
untrusted ports.
Whether the port uses strict prior-
ity or weighted fair queuing.
The default minimum/maximum
bandwidth for each of the eight
CoS queues per port.
(Not supported on the
OmniSwitch 6800.)
Whether the port is trusted or
untrusted
The maximum egress bandwidth
The maximum ingress bandwidth

Policy Rule Defaults

The following are defaults for the
Description
Policy rule enabled or disabled
Determines the order in which
rules are searched
Whether the rule is saved to flash
immediately
Whether messages about flows
that match the rule are logged.
How often to check for matching
flow messages.
Whether to count bytes or pack-
ets that match the rule.
(Only packets are counted on the
OmniSwitch 6800.)
OmniSwitch AOS Release 6 Network Configuration Guide
command to reset port settings to the defaults.
Command/keyword
qos port default 802.1p
qos port default dscp
qos port servicing mode
qos port q minbw maxbw
qos port trusted
qos port maximum egress-band-
width
qos port maximum ingress-band-
width
policy rule command:
Keyword
enable | disable
precedence
save
log
log interval
count
Default
0
0
strict priority queuing
minimum = best effort
maximum = port bandwidth
802.1Q and mobile ports are
always trusted; other ports are
untrusted
port bandwidth
port bandwidth
Default
enabled
0
enabled
no
60 seconds
packets are counted
September 2009
QoS Defaults
page 40-11