Honda Accord 2008 Manual page 1265

07/11/02 09:17:31 61TA0000_160_0026
Driveline/Axle
Intermediate Shaft Reassembly (cont'd)
6. Install a new outer seal (A) into the bearing support
(B) using the installer attachment (C), oil seal driver
(D), and a press. Press the seal until it is
−
3.8 4.2 mm (0.15 0.17 in.) below the surface of
the intermediate shaft.
＊０６
D
07GAD-PH70201
C
07MAD-PR90100
B
7. Install a new set ring.
＊０７
16-26
−
PRESS
A
Replace.
Pack the interior
of the outer seal.
Replace.
8. Install the two bolts (A) and the heat shield (B).
B
A
6 x 1.0 mm
9.3 N·m
(0.95 kgf·m,
6.9 lbf·ft)
＊０８
A
6 x 1.0 mm
9.3 N·m
(0.95 kgf·m,
6.9 lbf·ft)