Honda Accord 2008 Manual page 1616

07/11/02 09:29:47 61TA0000_200_0049
Rear Door Glass Outer Weatherstrip Replacement
4-door
NOTE:
• Put on gloves to protect your hands.
• Take care not to scratch the door.
1. Remove these items:
• Door panel (see page 20-35)
• Plastic cover, as needed (see step 2 on page
20-38)
2. Raise the glass fully.
3. Remove the screws from the front and rear edges
of the door.
＊０１
Fastener Locations
: Screw, 2
4. From the inside of the door, slide the clips (A) of the
door glass outer weatherstrip (B) to release the
hooks (C) from the flanges (D) of the door panel.
B
B
D
C
A A
(Engaged (Released
position) position)
5. Pull up the door glass outer weatherstrip (A) while
passing the front and rear edges of the
weatherstrip over the door sash outer trim (B) and
the door outer molding (C), then remove the
weatherstrip.
A
B
6. If the clips are damaged or stress-whitened, replace
them with new ones.
7. Before installing the door glass outer weatherstrip,
align the clips of the weatherstrip to the flanges
where the clips should be engaged by sliding them.
8. Push the clip portions of the rear door glass outer
weatherstrip into place securely.
ＴＡ０８ＡＢ４Ｊ１６１６６２２０３６１ＫＢＡＴ１０
＊０２
A
＊０３
C
20-47