Honda Accord 2008 Manual page 1289

07/11/02 09:19:40 61TA0000_170_0023
Power Steering
Pump Overhaul (cont'd)
27. Push in the cam ring (A) from the pump housing
cap hole (B) with a flat-tip screwdriver to make sure
the cam ring is fully seated against the outer case.
＊１４
B
28. Coat the new pump cover seal (A) with power
steering fluid, and install it into the groove in the
pump cover (B).
＊１５
29. Install the pump cover assembly over the pump
housing (C).
17-22
A
B
30. Align the bolt holes in the cover (A) with the
threaded holes in the pump housing. Install the
flange bolts loosely first, then tighten the flange
bolts to the specified torque alternately in two or
more steps.
31. Install the pump preload spring (A) in the pump
housing (B).
A A
Replace.
C
C
9 N·m
(0.9 kgf·m, 7 lbf·ft)
32. Install the pump housing cap (C) on the pump
housing, and tighten it to the specified torque.
NOTE: Be careful not to damage the pump outlet
hose connecting surface (D) pump housing when
installing the housing cap.
8 x 1.25 mm
20 N·m (2.0 kgf·m, 14 lbf·ft)
B
D
＊１６
A
＊１７