Honda Accord 2008 Manual page 1683

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:32:31 61TA0000_200_0116

Interior Trim

Trim Removal/Installation - Pillar Areas (cont'd)

14. Reinstall the C-pillar trim (A).

–1 Set the rear hook (B) and the bottom hooks (C)

–2 Place the trim over the C-pillar (F), and fit its

–3 Install the C-pillar lid cap (K) fully into the clip.

of the trim to the rear shelf (D) and the rear side

trim panel (E).

rear clip (G) into the hole in the C-pillar and the

C-pillar lid clip (H) into the holes in the

headliner (I) and the side curtain airbag bracket

(J), then lightly push the trim into place.

• Make sure the side curtain airbag isn't tucked

down under the clip and the ribs.

• Apply pressure to the areas of the trim on the

rear clip until the clip fitting is felt. If you

push too hard, the clip will be damaged, and

it will not hold the trim properly.

• Make sure the rear clip portions of the trim

don't come off the body by tugging on the

15. Fit the projection (A) and the clips into the holes in

the body, then push the roof portion of the C-pillar

trim (B) until its clips snap into place securely, and

push the front edge of the trim until its hooks (C)

snap to the B-pillar upper trim (D) securely.

Fastener Locations

16. Reinstall the screw to the coat hanger portion of the

C-pillar trim (A).

Fastener Location

Chapters

Table of Contents