07/11/02 08:48:07 61TA0000_140_0106
Automatic Transmission
DTC Troubleshooting (cont'd)
14. Connect PCM connector C (49P).
15. Disconnect the input shaft (mainshaft) speed
sensor connector.
16. Turn the ignition switch to ON (II).
17. Measure the voltage between input shaft
(mainshaft) speed sensor connector terminal No. 1
and body ground.
*02
Is there about 5 V ?
YES
NO
−
14-104
INPUT SHAFT (MAINSHAFT)
SPEED SENSOR CONNECTOR
VCC2 (YEL/BLU)
Wire side of female terminals
−
Go to step 18.
Go to step 27.
18. Turn the ignition switch to LOCK (0).
19. Disconnect PCM connector B (49P).
20. Check for continuity between input shaft
(mainshaft) speed sensor connector terminal No. 2
and body ground.
INPUT SHAFT (MAINSHAFT)
SPEED SENSOR CONNECTOR
NM (WHT/RED)
Wire side of female terminals
Is there continuity?
YES
−
Repair short to body ground in the wire
between PCM connector terminal B18 and the input
shaft (mainshaft) speed sensor, then go to step 30.
NO
−
Go to step 21.
*03