Honda Accord 2008 Manual page 1113

07/11/02 09:19:21 61TA0000_140_0270
Automatic Transmission
Transmission Installation (cont'd)
72. Install the under-hood fuse/relay box.
73. Refill the transmission with ATF (see step 4 on page
14-242).
74. Install the battery base.
75. Install the air cleaner assembly (see page 11-385)
and the intake air duct.
76. Do the battery installation procedure (see page
22-90).
77. Loosely install the front strut brace mounting nuts
(A) on the front strut brace (B), and install the hose
(C) on its clamps (D).
＊３７
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
14-268
A
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
B
D
C
78. Set the parking brake. Start the engine, and shift
the transmission through all gears three times.
79. Check the shift lever operation, the A/T gear
position indicator operation, and the shift cable
adjustment.
80. Place a floor jack under the lower arm, and raise
the suspension to load it with the vehicle's weight.
Do not place the jack against the ball joint pin of the
knuckle.
Tighten the damper pinch bolt and the damper fork
mounting nut while holding the mounting bolt to
the specified torque.
81. Tighten the front strut brace mounting nuts on top
of the damper to the specified torque value.
82. Install the front wheels.
83. Install the splash shield.
84. Check and adjust the front wheel alignment
(see page 18-5).
85. Start the engine with the shift lever in P or N, and
warm it up to normal operating temperature (the
radiator fan comes on).
86. Turn the engine off, and check the ATF level
(see page 14-241).
87. Do the road test (see page 14-215).