Honda Accord 2008 Manual page 1392

07/11/02 09:28:48 61TA0000_180_0059
How to Retrieve DTCs
1. With the ignition switch at LOCK (0), connect the
HDS (Honda Diagnostic System) to the data link
connector (DLC) (A) located under the driver's side
of the dashboard.
＊０２
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle
and the TPMS control unit. If it doesn't,
troubleshoot the DLC circuit (see page 11-208).
4. Follow the prompts on the HDS to display the
DTC(s) on the screen. After determining the DTC,
refer to the DTC troubleshooting.
NOTE: See the HDS Help menu for specific
instructions.
5. Turn the ignition switch to LOCK (0).
A
How to Clear DTCs
1. With the ignition switch at LOCK (0), connect the
HDS to the data link connector (DLC) (A) located
under the driver's side of the dashboard.
A
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle
and the TPMS control unit. If it doesn't,
troubleshoot the DLC circuit (see page 11-208).
4. Clear the DTC(s) by following the screen prompts
on the HDS.
NOTE: See the HDS Help menu for specific
instructions.
5. Turn the ignition switch to LOCK (0).
＊０３
18-59