Honda Accord 2008 Manual page 1494

07/11/02 09:34:58 61TA0000_190_0073
DTC 12-12: Right-front Wheel Speed Sensor
Short to the Other Sensor Circuit
DTC 14-12: Left-front Wheel Speed Sensor
Short to the Other Sensor Circuit
DTC 16-12: Right-rear Wheel Speed Sensor
Short to the Other Sensor Circuit
DTC 18-12: Left-rear Wheel Speed Sensor
Short to the Other Sensor Circuit
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle. Drive the vehicle at 13 mph
(20 km/h) or more, and go a distance of 328 ft
(100 m) or more.
NOTE: Drive the vehicle on a straight section of
road, not on a lift.
4. Check for DTCs with the HDS.
Is DT C 12-12, 14-12, 16-12, and/ or 18-12
indicated?
YES − Go to step 5.
NO − Intermittent failure, the system is OK at this
time. Check for loose terminals between the wheel
speed sensor 2P connector and the VSA modulator-
control unit 36P connector. Refer to intermittent
failures troubleshooting (see page 19-47).
5. Turn the ignition switch to LOCK (0).
6. Disconnect the VSA modulator-control unit 36P
connector (see step 3 on page 19-142).
7. Check for continuity between the appropriate VSA
modulator-control unit 36P connector wheel speed
sensor GND terminals (see table).
DTC
Appropriate
12-12
14-12
16-12
18-12
VSA Modulator-control Unit 36P
Connector Terminal
Other Terminals
Terminal
No. 10 No. 6 No. 4 No. 8
No. 6 No. 10 No. 4 No. 8
No. 4 No. 10 No. 6 No. 8
No. 8 No. 10 No. 6 No. 4
VSA MODULATOR-CONTROL UNIT 36P CONNECTOR
FL-GND (GRN)
DTC 12-12
RR-GND (PUR)
RL-GND (RED)
DTC 14-12
FL-GND (GRN)
RR-GND (PUR)
DTC 16-12
RR-GND (PUR)
FL-GND (GRN)
DTC 18-12
RL-GND (RED)
RR-GND (PUR)
FL-GND (GRN)
Wire side of female terminals
Is there continuity?
−
YES Repair short in the wires between the
appropriate wheel speed sensor and the VSA
modulator-control unit.
NO − Go to step 8.
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ１２１２ＦＡＡＴ００
FR-GND (PUR)
FR-GND (PUR)
RL-GND (RED)
FR-GND (PUR)
RL-GND (RED)
FR-GND (PUR)
(cont'd)
19-73
＊０１