Honda Accord 2008 Manual page 1611

07/11/02 09:29:45 61TA0000_200_0044
Doors
Rear Door Glass and Regulator Replacement
4-door
NOTE: Put on gloves to protect your hands.
1. Remove the door panel (see page 20-35).
2. Disconnect the power door lock actuator connector
(A), and detach the harness clips (B). Remove the
plug caps (C).
＊０１
A
3. Pass the wire harness (D) through the hole (E) in the
plastic cover (F), then remove the plastic cover.
NOTE: Remove the glue from the door surface. If
the plastic cover is damaged or torn, replace it.
20-42
D
C F
B
E
4. Carefully move the glass (A) until you can see the
bolts, then remove them. Release the glass from
the holder (B), then remove it from the regulator (C),
and carefully lower the glass. Take care not to drop
the glass inside the door.
Fastener Locations
: Bolt, 2
C
C
5. Remove the bolt (A) from the rear lower channel (B).
Pull the glass run channel (C) away as needed, and
remove the screw (D).
Fastener Locations
A : Bolt, 1
B
6 x 1.0 mm
8 N·m
(0.8 kgf·m, 6 lbf·ft)
ＴＡ０８ＡＢ４Ｊ５４４０００２０３７１ＫＢＡＴ５０
B
A
A
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
D : Screw, 1
4 x 0.7 mm
4 N·m
(0.4 kgf·m,
3 lbf·ft)
D
C
A
＊０２
＊０３