Honda Accord 2008 Manual page 1363

07/11/02 09:28:02 61TA0000_180_0030
Front Suspension
Stabilizer Bar Replacement (cont'd)
30. Align the front subframe using the frame
positioning guide pin. Vertically install the frame
positioning guide pin, and align the right-rear
corner of the front subframe and vehicle frame
holes, then loosely tighten the subframe mounting
bolt (A) until the front subframe contacts the body
frame.
＊１５
A
14 x 1.5 mm
31. Loosely tighten the left-rear subframe mounting
bolt using the same procedure as the right-rear
with the frame positioning guide pin.
32. Loosely install the new 12 mm flange bolts (B) to
the subframe rear bracket.
18-30
B
070AG-SJAA10S
12 x 1.25 mm
Replace.
33. Torque the subframe mounting bolts to the
specified torque values starting with the right-rear
bolt. Use the frame positioning guide pin when
tightening the rear side bolts (A).
NOTE:
• Torque the bolts in the sequence shown.
• Before tightening the front side subframe
mounting bolts (B), raise the jack and loosely
install the 12 mm flange bolts (C) to align the
subframe front bracket.
12 x 1.25 mm
93 N·m (9.5 kgf·m, 69 lbf·ft)
Replace.
A
14 x 1.5 mm
103 N·m (10.5 kgf·m, 75.9 lbf·ft)
B C
14 x 1.5 mm 12 x 1.25 mm
103 N·m 54 N·m
(10.5 kgf·m, 75.9 lbf·ft) (5.5 kgf·m, 40 lbf·ft)
34. Check all of the front subframe mounting bolts, and
retighten if necessary.
＊１６