Honda Accord 2008 Manual page 1563

07/11/02 09:37:24 61TA0000_190_0142
VSA System Components
VSA Modulator-Control Unit Removal and Installation (cont'd)
3. Disconnect the VSA modulator-control unit 36P connector (A) by pushing the lock (B) and pulling down the lever
(C); the connector disconnects itself.
＊０２
4. Disconnect the six brake lines from the VSA modulator-control unit.
NOTE: Brake lines are connected to the master cylinder (D) and to the left-rear (E), the right-front (F), the left-front
(G), and the right-rear (H) brake systems.
5. Remove the VSA modulator-control unit (I) with the bracket (J) from the body.
6. Remove the receiver line (K) from the bracket, then remove the clips (L).
7. Remove the VSA modulator-control unit from the bracket.
19-142
B
A
L
L
K
G
F
E
C
H
15 N·m
(1.5 kgf·m, 11 lbf·ft)
I
D
22 N·m
(2.2 kgf·m,
16 lbf·ft)
J
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)