Honda Accord 2008 Manual page 1668

07/11/02 09:32:24 61TA0000_200_0101
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
Front Door Sill Area - 4-door
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the trim and the
panels.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Driver's side: Remove the front side cap from the
front door sill trim (see step 1 on page 20-284).
2. Driver's side: Remove the opener lock cylinder, and
loosen the opener mounting bolt (see step 2 on
page 20-284).
3. Driver's side: Remove the screw securing the front
door sill trim and trunk lid opener/fuel fill door
opener (see step 3 on page 20-285).
4. Detach the hooks (A) and tabs (B) from the kick
panel (C) and the B-pillar lower trim (D), and pull
the front door sill trim (E) up by hand to detach the
clips, then remove it.
Driver's side
＊０１
Fastener Locations
: Clip, 4
(Orange)
E
E
A
B
D
Passenger's side
Fastener Locations
: Clip, 4
(Orange)
A
B
C
5. Remove the driver's kick panel (A) or the
passenger's kick panel (B).
–1 Pull out the door opening seal (C) as needed
from the kick panel hooks (D) and the door
opening flange.
–2 Pull the kick panel back by hand to detach the
clips, then remove it.
Driver's side
Fastener Locations
: Clip, 2
(Gray)
A
B
C
C
C
ＴＡ０８ＡＢ４Ｊ２６２７３４０００００ＫＤＡＴ１１
E
E
A
B
D
A
D
(cont'd)
20-99
＊０２
＊０３