Honda Accord 2008 Manual page 1633

07/11/02 09:30:22 61TA0000_200_0066
Glass
Windshield Replacement (cont'd)
15. Attach the molding upper seal (A) with adhesive
tape to the inside surface of the molding (B) as
shown.
＊０８
A
16. Set the windshield in the opening, and center it.
Make alignment marks (A) across the windshield
and the body with a grease pencil at the four points
shown. Make sure the pins (B) of both upper clips
(C) contact with the edge of the body holes. Be
careful not to touch the windshield where adhesive
will be applied.
＊０９
17. Remove the windshield.
20-64
B Inside
A
Inside
B
C
A
18. With a sponge, apply a light coat of glass primer to
the windshield (A) along the edge of the molding
(B) and rubber dams (C) as shown, then lightly wipe
it off with gauze or cheesecloth:
• Apply glass primer to the molding.
• Do not apply body primer to the windshield, and
do not get body and glass primer sponges mixed
up.
• Never touch the primed surfaces with your hands.
If you do, the adhesive may not bond to the
windshield properly, causing a leak after the
windshield is installed.
• Keep water, dust, and abrasive materials away
from the primed surfaces.
: Apply glass primer here.
C
B
B
13.5 mm
(0.53 in.)
A
Inside
C
Inside
A
C
C
11 mm
A A
(0.43 in.)
Inside
C
＊１０
B
C
A