Honda Accord 2008 Manual page 1351

07/11/02 09:27:35 61TA0000_180_0018
Front Suspension
Knuckle/Hub/Wheel Bearing Replacement (cont'd)
6. Press a new wheel bearing (A) into the knuckle (B)
using the old bearing (C), a steel plate (D), the
bearing driver attachment, the support base, and a
press.
NOTE:
• Install the wheel bearing with the wheel speed
sensor magnetic encoder (E) (brown color),
toward the inside of the knuckle.
• Remove any oil, grease, dust, metal debris, and
other foreign material from the encoder surface.
• Keep any magnetic tools away from the encoder
surface.
• Be careful not to damage the encoder surface
when you insert the wheel bearing.
＊１４
B
07GAD-SD40101
18-18
Press
D
C
A
INSIDE
07965-SD90100
7. Check the front knuckle ring (A) for damage or
deformation, and replace it if necessary. When
installing the new front knuckle ring, align the ledge
portion (B) on the ring with the ball joint housing
cut out (C) on the knuckle. and be careful not to
damage or deform it.
NOTE: If the knuckle ring was removed, replace it
with a new one.
B
E
8. Install the snap ring (A) securely in the knuckle (B).
B
A
D
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
9. Install the splash guard (C), and tighten the screws
(D) to the specified torque value.
＊１５
A
Replace.
C
＊１６
C